VYMENA XENON VYBOJOK PHILIPS, E39
Napísané: Streda, 1. Apríla 2009, 19:32
Zdalo sa mi ze xenony uz pomenej svietia tak som si objednal nove Philips D2S 85122 (seria OEM)
chcem si ich sam vymenit len nejak to nejde...
nasiel som navod :
step by step:
1. removeelectric connection from back of bulb by turning approx 1/4 turn anti-clockwise
2. pull of rubber grommet, tis quite flexible and needs quite a tug to come off
3. you will now see back of bulb with a black holder, turn the holder anti-clockwise approx 1/4 turn and the bulb and holder will come off. ensure you apply pressure to the bulb to hold it in place or it will fall.
4.carefully pull back holder (ensuring you hold onto the bulb casing) and removefrom car.
5. Now look at the hole where bulb goes and at the top is a little tab with 2 smaller tabs either side. the new bulb must line up with these.
6. insert new bulb, lining up with the tabs. hold in placewith one finger whilst putting the holder overthe back of the connector. dont let the bulb loose or it will move from the tabs.
7. the holder also has an indented part which must line up with a tab on the exterior of the bulb housing. aslong as you keep this indentation to the bottom, when the holder clicks overthe bulb, it will fall into place.
8. turn 1/4 turn clockwise to tighten, replace grommet and reconnect wiring.
Dostal som sa po prvy bod, odpojenie cerveneho konektora... dalej som aj zohodil tu gumu z obvodu ale v strede ako keby o nieco drzala tak nesla dole, predtym som skusal vytiahnut tu ziarovku rucne otocenym proti smeru hod. ruciciek ale neslo to a cele to davalo take krehke zvuky tak som to nechcel nejak silit... je tam nejaka finta, robili ste to uz niekto?
chcem si ich sam vymenit len nejak to nejde...
nasiel som navod :
step by step:
1. removeelectric connection from back of bulb by turning approx 1/4 turn anti-clockwise
2. pull of rubber grommet, tis quite flexible and needs quite a tug to come off
3. you will now see back of bulb with a black holder, turn the holder anti-clockwise approx 1/4 turn and the bulb and holder will come off. ensure you apply pressure to the bulb to hold it in place or it will fall.
4.carefully pull back holder (ensuring you hold onto the bulb casing) and removefrom car.
5. Now look at the hole where bulb goes and at the top is a little tab with 2 smaller tabs either side. the new bulb must line up with these.
6. insert new bulb, lining up with the tabs. hold in placewith one finger whilst putting the holder overthe back of the connector. dont let the bulb loose or it will move from the tabs.
7. the holder also has an indented part which must line up with a tab on the exterior of the bulb housing. aslong as you keep this indentation to the bottom, when the holder clicks overthe bulb, it will fall into place.
8. turn 1/4 turn clockwise to tighten, replace grommet and reconnect wiring.
Dostal som sa po prvy bod, odpojenie cerveneho konektora... dalej som aj zohodil tu gumu z obvodu ale v strede ako keby o nieco drzala tak nesla dole, predtym som skusal vytiahnut tu ziarovku rucne otocenym proti smeru hod. ruciciek ale neslo to a cele to davalo take krehke zvuky tak som to nechcel nejak silit... je tam nejaka finta, robili ste to uz niekto?
