... všetko o BMW ...
Moderátori: barabas, alfi666, jkk
Rottwa napísal:Nefuka ziadny znamena ze mas nastavene otacky ventilatora ale ventilator sa nekruti ? Nie je ho ani pocut ?
Before filling, switch on ignition, set heater control to
maximum temperature and set fan to low speed. This opens
heating valves and installed auxiliary water pump runs if
necessary.
Perform filling operation slowly.
Fill expansion tank completely and wait until coolant emerges at
vent point(s) without bubbles. Close bleed screw(s).
Set heater control to maximum temperature and set fan to low
speed. This opens heating valves and installed auxiliary water
pump runs if necessary. Run engine and flush out engine
cooling circuit with three or four short bursts of throttle (approx.
4500 to 5000 rpm) (sealing cap open). While doing so, do not
run engine for longer than approx. 30 sec. to prevent coolant
from heating up and expanding. If coolant level in expansion
tank drops during this, top up expansion tank to the brim with
coolant. Attach screw cover and run engine to heat it up until
thermostat opens.